Orthodontic Appliances

Headgear    |   Rapid Palatal Expander  |   Nance Appliance   |   Distil Jet Appliance   |   Pendulum Appliance   |   Thumb/Finger Appliance   |   Lip Bumper   |   Tongue Thrusting Appliance   |   Frankel Appliance   |   Pendex Appliance   |  Temporary Anchorage Devices

appliances

Headgear is often used to correct an excessive overbite. This is done by placing pressure against the upper teeth and jaw, which would hold the teeth in position or help move them into better positions. The severity of the problem determines the length of time headgear needs to be worn. The key to success with your headgear appliance is consistency. Headgear must be worn a certain number of hours per day, and if not, it must be made up the following day.

Headgear should never be worn while playing sports and should also be removed while eating or brushing your teeth.

Back to top


Rapid Palatal Expander

Attached to the upper molars through bonding or by cemented bands, the Rapid Palatal Expander is an orthodontic device used to create a wider space in the upper jaw. It is typically used when the upper jaw is too narrow for the lower jaw or when the upper teeth are crowded or blocked out of the dental arch.

When patients are still growing, their connective tissue between the left and right halves of their upper jaw is very responsive to expansion. By simply activating the expander through turning a screw in the center of the palatal expander, with a special key we provide, gradual outward pressure is placed on the left and right halves of the upper jaw. This pressure causes an increased amount of bone to grow between the right and left halves of the jaw, ultimately resulting in an increased width.

 

Back to top


Nance Appliance

The Nance Appliance is used to prevent upper molars from rotating or moving forward after you’ve worn a headgear, a Wilson’s arch or any other appliance to move your molars back. Some patients wear the Nance Appliance while they are awaiting their bicuspids to grow into place.

The appliance is made of two bands that are cemented onto the first molars and a wire spans the roof of the mouth from one molar to the other. An acrylic pad or “button” covers the wire that touches the roof of your mouth directly behind your front teeth.

Patients should always brush around the bands daily. Do not eat sticky, chewy candy as it can loosen your appliance.

Back to top


Distal Jet Appliance

The Distal Jet Appliance is a non-removable lingual appliance that is used to move upper teeth backward faster and more predictably than headgear. The Distal Jet distalizes molars and corrects teeth that have rotated. This appliance corrects class II problems.

The Distal Jet Appliance uses a solid track wire and two sets of locking screws on each side. The appliance is self-limiting by design because it has a distal stop attached to the tracking wire. The Distal Jet can be converted to a Nance Appliance by tightening the distal and anterior locks against the track wire and adding a Nance holding arch.

Back to top


Pendulum Appliance

The Pendulum Appliance is used to correct class II malocclusions by distalizing upper molars. It’s used to correct the patient’s bite on the side of their mouth.

The Pendulum Appliance consists of a plastic “button” that touches the roof of the mouth and resilient wire springs that act in a broad swinging arc to move the molars back. The appliance uses the roof of the mouth as an anchor to move the molars back into their correct positions. Patients usually wear this appliance for 3 to 5 months.

Back to top


Thumb/Finger Appliance

Sucking is a natural reflex that relaxes and comforts babies and toddlers. Children usually cease thumb sucking when the permanent front teeth are ready to erupt. Typically, children stop between the ages of 2 and 4 years. Thumb sucking that persists beyond the eruption of primary teeth can cause improper growth of the mouth and misalignment of the teeth. If you notice prolonged and/or vigorous thumb sucking behavior in your child, talk to your dentist.

One solution to thumb sucking is an appliance called a "fixed palatal crib." This appliance is put on the child's upper teeth by an orthodontist. It’s placed behind on the upper teeth on the roof of the mouth. The crib consists of semicircular stainless steel wires that are fastened to molars using steel bands. The stainless steel wires fit behind the child's upper front teeth, and they are barely visible. The crib usually stops the habit of thumb sucking within the first day of use.

Back to top


Lip Bumpers

We like to avoid pulling teeth as often as possible, so we use lip bumpers on our patients who need to create more room for their crowded teeth. The lip bumper is a wire on the lower jaw that extends from one molar to another and keeps lips and cheeks from touching your teeth. When you move your mouth or speak, your lips and cheeks push on the bumper, and the bumper applies pressure to the teeth. This pressure pushes the molars back, creating more space for overcrowded teeth.

If you have a lip bumper, please remember to leave it in while eating, but do not eat hard or sticky foods. Proper, thorough brushing should remove any food that gets stuck in your lip bumper.

Back to top


Tongue Thrusting Appliance

Tongue thrusting occurs when the patient presses his or her tongue against the front teeth, usually when swallowing, speaking or resting the tongue. If thrusting is constant, this can cause problems with teeth alignment and must be fixed.

We prefer to correct tongue thrusting by giving patients a tongue thrusting appliance. This appliance, similar to a mouth guard, is usually worn at night. Other times, a more permanent appliance is prescribed and can be only be adjusted by our office.

Back to top


Frankel Appliance

The Frankel Appliance is a functional orthopedic appliance that is used to help create additional space for permanent teeth to erupt by expanding the arches. It stimulates growth of the lower jaw which will better align the upper and lower teeth.  The Frankel can also be used to help with protrusion or overjet by retracting the upper teeth and creating a better bite.

Frankel appliances are typically worn full-time for 18 – 24 months and possibly longer if the permanent teeth have not fully erupted.

Back to top


Pendex Appliance

The Pendex Appliance is a Pendulum Appliance that uses an expansion screw to widen the upper palate, correcting class II malocclusions and the patient’s bite.

The Pendex Appliance consists of a plastic “button” that touches the roof of the mouth. Within this button, there is a keyhole where you are to place the key and turn it according to your orthodontist’s instructions. This turning will widen the appliance, thus widening your upper palate. Patients usually wear this appliance for three to six months.

Back to top


Temporary Anchorage Devices (TADs)

One of the many important advances in orthodontics has been the development of temporary anchorage devices, or TADs. Made of a bio-compatible titanium alloy, TADs are miniscrew anchors which are inserted into specific places in the mouth to be used as a fixed point from which teeth can move. Before TADs, orthodontists who wanted to move some teeth while keeping others still, or to achieve orthodontic movement in a mouth with missing teeth, had to rely on headgear for their fixed point. But TADs now provide an option for that fixed point that is smaller, more discrete, more efficient and requires significantly less work for the patient.

Temporary anchorage devices may not be recommended for everyone. Contact us if you’d like to know more about TADs and how they can potentially prevent you from needing orthodontic headgear.

Back to top